To Turn Off Gas Appliance, Thermopile | Heat & Glo LifeStyle ST-CFL-24LP

LIGHTING INSTRUCTIONS

1."STOP!" Readthesafetyinformationonprevious page.

2.Open the control access cover (logs #3 and 4 in CFL models) or (logs #4 and 5 in ST-CFL model),refertoyourLogPlacementInstructions.

3.Turn the valve control knob to the "OFF" position. To do this, you must turn the knob

clockwise to the "Pilot" position, and then press in and continue turning

clockwise to the "OFF" position.

GAS CONTROL VALVE

NOTE: Knob cannot be turned from "PILOT" to "OFF" unless knob is pushed in slightly. Do not force.

4.WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. Then smell for gas, including near the floor. If you then smell gas, STOP! Follow "B" in the safety information previous page. If you don't smell gas, go to the next step.

5.The pilot should not require accessing for lighting purposes. The pilot is located at the end of the burner.

THERMOPILE

PILOT BURNER

6.To put the control in the "Pilot" position, turn the

control knob counter-clockwise to the "Pilot" position.

7.To light the pilot depress the control knob and then depress the red piezo button until it makes a clicking sound. It may be necessary to repeat this step. If the pilot does not light after 10 seconds, go back to step 3. The control knob should be held down for a MINUTE after pilot ignition.

•If the control knob does not pop out when released, STOP-shut off the gas supply to the fireplace control valve, and IMMEDI- ATELY call your service technician or gas supplier.

•If the pilot will not stay lit after two tries, turn the control knob to the "OFF" position and call your service technician or gas supplier.

8.After the pilot has been lit, the burner can be turned on by turning the knob counter-clockwise to the "ON" position. Flip the ON/OFF switch to the "ON" position. (This is located to the right on the burner leg and behind the control access cover.)