Heat & Glo LifeStyle CFL-24LP-B, CFL-30LP-B Operating Guidelines and Maintenance Instructions

3.0 OPERATING GUIDELINES AND MAINTENANCE INSTRUCTIONS

Upon completing the gas line connection, a small amount of air will be in the lines. When first lighting the pilot light, it will take a few minutes for the lines to purge themselves of this air. Once the purging is complete, the pilot and burner will light and operate as indicated in the instruction manual. Subsequent lighting of the appliance will not require such purging.

WARNING:

Be sure fireplace screen or glass doors are in place when burning fireplace logs. Unless other provisions for combustion air are provided, the screen or doors shall have an opening for introduction of combustion air. THIS GAS LOG SET IS NOT DE-

SIGNED TO OPERATE WITH AIR TIGHT GLASS DOORS. If gas odor is noticeable, turn control knob to "OFF" position and check all connections for leaks. DO NOT USE OPEN FLAME. Adequate combustion and cooling air must be provided or the unit will not function properly.

To obtain proper operation, it is imperative that the pi- lot and main burner flame characteristics are steady, not lifting or floating.

Typically, the top 3/8 inch (10mm) of the thermopile should be engulfed in the pilot flame (Figure 7).

Periodically remove the logs and examine the burner. If dirty, clean with a soft brush. Also examine the area around the burner air shutter and the pilot. Any dirt or lint in this area should be removed. This will ensure long life and trouble-free operation. When the appliance is put back in service, check the burner flame patterns with Figure 8.

The appliance and venting system should be inspected before initial use and inspected and cleaned at least annually by a qualified field service person.

Figure 7

CFL-18-B

CFL-24-B

CFL-30-B

ST-CFL24

Figure 8

LPG (PROPANE) INFORMATION

THE FOLLOWING WARNING APPLIES TO IN- STALLATIONS USING L.P. (PROPANE) GAS:

WARNING: To avoid possible injury, fire and explo- sion, please read and follow these precautions and all instructions on this appliance before lighting the pilot. This appliance uses L.P. (Propane) gas which is heavier than air and will remain at floor level if there is a leak. Before lighting, smell at floor level and/or use other means (such as using a commer- cially-available, non-corrosive leak check solution on all piping and connections, using a gas detector, etc.) to check for gas leaks. NOTE: L.P. (Propane) gas can become odorless and CANNOT always be detected by smell. If you smell gas, detect a gas leak, or sus- pect that a gas leak exists, follow these rules.

1.Get all people out of building.

2.DO NOT light matches. DO NOT turn electric lights or switches on or off in area. DO NOT use an electric fan to remove gas from area. DO NOT use a telephone inside the building.

3.Shut off gas at L.P. tank outside of building.

4.Telephone gas company and fire department and ask for instructions.

Before hanging up, give your name, address and phone number. DO NOT go back into building.

If your L.P. tank runs out of fuel, turn off gas at the appliance. After L.P. tank is refilled, appliance must be re-lit according to manufacturer’s instructions. If the gas control has been exposed to WATER in any way, DO NOT try to use it. It must be replaced. DO NOT attempt repair on gas control or appliance.

Tampering is DANGEROUS and voids all warranties. Any component that is found to be faulty must be re- placed with an approved component.

Heat & Glo • CFL-18/24/30-B, ST-CFL-24 • 526-900 Rev. F • 7/05 17