Heat & Glo LifeStyle PALOMA-BZ-MOD owner manual Loss of Power and Battery Backup Usage

				IGNITION MODULE
				3 VAC	I
	PLUG-IN 3V					INTERMITTENT
	TRANSFORMER		FLAME			PILOT IGNITOR
					S
ON/OFF			SPARKER/SENSOR
WALL
SWITCH
	IGNITION
	MODULE
	(3V)
					WHT
			BATTERY	BLACK	ORG
	VALVE
			PACK		GROUND TO
					APPLIANCE CHASSIS
		REMOTE		RED	*
			HOT
NEUTRAL	GROUND	CONTROL
				BRN	BRN
					ORG	GRN
				PIGGYBACK
			TRANSFORMER	ON/OFF SWITCH
			3 VAC
			PLUG IN
	JUNCTION BOX				VALVE

NOTE: Appliance will not operate unless properly grounded.

Figure 7.2

CAUTION

Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING

Shock hazard.

•Replace damaged wire with type 105º C rated wire.

•Wire must have high temperature insulation.

D. Loss of Power and Battery Backup Usage

1.	Disconnect the power supply.		Unplug when
2.	Remove the front door assembly and lower access
			using batteries
	panel.
3.	Place two "D" cell batteries into the battery	holder.
	(Figure 7.3)
4.	Turn on appliance and verify it is operational.
5.	Replace lower access panel and front door assembly.
	CAUTION
If IPI battery back-up is installed:
• Do not install batteries if the backup mode may not be used
	for extended time.
•	Batteries may leak.
•	Install batteries only when needed for power outage.
			BATTERY LOCATION
			Figure 7.3
	Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/12			29