Heat Controller BG-103A service manual Power Cord, Thermistor

2.3.4 POWER CORD

1.Remove the control box. (Refer to section 2.1.3)

2.Unfold the control box. (Refer to section 2.3.3)

3.Disconnect the grounding screw from the Base pan.

4.Disconnect 2 receptacles.

5.Remove a screw which fastens the clip cord.

6.Pull the power cord. (See Fig. 13)

7.Re-install the components by referring to the

removal procedure, above.

(Use only one ground-marked hole, , for ground connection.)

8.If the supply cord of this appliance is damaged, it must be replaced with the factory-authorized and specified cord.

Figure 13

2.3.5 THERMISTOR

1.Remove the control box. (Refer to section 2.1.3)

2.Unfold the control box. (Refer to section 2.3.3)

3.Disconnect all the leads of thermistor terminals.

4.Remove the thermistor. (See Fig. 14)

5.Re-install the components by referring to the removal procedures, above.

	C
	ool
	Energy
	Saver
	Fan
		F1	LOW
		F2
		F3	MED
	Timer		HIGH
MODE			'F
	TIMER	TEMP
		FAN
		SPEED	POWER

Figure 14

—8—