Heat Controller | DVC/DVH Remote Controller |
|
|
Remote Control Instructions
| 1. | The remote controller can be used to control and operate the unit |
| 2. | The remote’s signal can transmit up to 26 ft. (8 m) away. |
| 3. Any obstructions between the signal of the remote control and the | |
|
| indoor unit can interfere, limiting the capacity of the signal. |
26 ft.(8 m) |
| |
| 4. When a button is pressed on the remote control, the indoor unit | |
| ||
will emit a “beep”, which indicates that the command has been received and transmitted to the indoor unit.
! Caution
• The air conditioner will not operate if curtains, doors or other materials block the signal from the remote control to the unit.
• Avoid spilling any liquid into the remote.
• Do not expose to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. Use curtains to prevent the sunlight from interferring with the receiver’s signal.
• If other electrical appliances signals react to the signal sent by the remote controller relocate these appliances.
• When replacing batteries, do not use old batteries
•If you do not use the remote for a prolonged period of time, remove the batteries. Otherwise they may leak and damage the remote
Battery Specification
To use the remote control, it is necessary to install two (R03/LR03x2) alkaline AAA batteries.
Battery Replacement
1.Batteries should be replaced when there is not a “beep” heard from the indoor unit or the signal indicator light does not illuminate when buttons are pressed on the remote or when the indoor unit does not respond to the remote controls commands.
2.To replace the batteries:
A.Remove the cover by pressing and sliding off.
B.Remove the old batteries and insert the new batteries, placing the (+) and
C.Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all user settings. After inserting new batteries, the remote controller must be reprogrammed for any user specific settings.
3
