Heat Controller VMH30SB-1 specifications Energy-SavingCoolingMode, Forcedoperation, Test operation

Operating Instructions

Energy-SavingCoolingMode

Energy-saving cooling mode can save energy in cooling and healthy dehumidification operation, because it can operate efficiently by setting body-adaptation time according to the change of time and temperature and adjusting automatically desired temperature.

1.Press the START/STOP BUTTON to start the unit.

2.Open the door on the remote controller.

Select cooling operation or healthy dehumidification operation.

3.Press the ENERGY-SAVING COOLING MODE BUTTON.

4.To cancel the energy-saving cooling mode, press the ENERGY-SAVING COOLING MODEL BUTTON again and unit will operate in previous mode(Cooling or healthy dehumidification mode).

Forcedoperation

Operation procedures when the remote control can't be used.

The operation will be started if the ON/OFF button is pressed.

If you want to stop operation, re-press the button.

ON/OFF

button

	Cooling Model		Heat pump Model
		Room Temp. ≥ 24°C(75.2°F)	21°C(69.8°F) ≤ Room Temp. < 24°C(75.2°F)	Room Temp. < 21°C(69.8°F)
Operating mode	Cooling	Cooling	Healthy Dehumidification	Heating
Indoor FAN Speed	High	High	High	High
Setting Temperature	22°C(71.6°F)	22°C(71.6°F)	23°C(73.4°F)	24°C(75.2°F)

Test operation

During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature and resets in 18 minutes.

During test operation, if remote controller signal is received, the unit operates as remote controller sets.

If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer will sound 1 "beep".

If you want to stop the operation, re-press the button.

Owner's Manual 13