Heat Controller Select The Best Location, VMH 30/36 SERIES, Heat Controller, Inc, Indoor unit

Heat Controller, Inc. VMH 30/36 SERIES Installation, Operation & Maintenance

SELECT THE BEST LOCATION

5 inches

Indoor unit

There should not be any heat source near the unit.

There should not be any obstacles blocking the air circulation.

A place where air circulation in the room is good.

A place where drainage can be easily done.

A place where noise prevention is taken into consideration.

Do not install the unit near a door way.

Ensure the clearness indicated by arrows in the figure on the right are adhered to leaving space away from any walls, ceiling, or other obstacles.

There should not be any direct sunlight.

If unavoidable, sunlight prevention should be taken into consideration. Direct sunlight may block the ability of the unit to reduce the signal from the remote controller.

Outdoor unit

If an awning is built over the unit to prevent direct sunlight or rain, be careful that heat radiating from the condenser is not obstructed.

There should not be any animals or plants kept near the unit which could be affected by hot air discharged.

Ensure the clearances indicated by the arrows on the right are adhered to, leaving space away from any walls, fences, plants, or other obstacles.

NOTE: See outdoor installation precautions on page 7 for additional information.

6 inches

6 inches

8 feet

1 foot

1 foot 2 feet

7 feet

2 feet

ACCESSORIES
Number	Name of Accessories		Qty
1	Installation Plate		1
2	Clip Anchor		5-8(depending on models)
3	Self-tapping Screw A ST3.9x25		5-8(depending on models)
4	Seal		1
5	Drain Joint		1
6	Remote controller		1
7	Self-tapping Screw B ST2.9x10	optional	2
8	Remote controller holder	parts	1

NOTE: In addition to the parts above, other parts may need to be purchased locally. such as copper line sets, etc.

3