Installation, Operation & Maintenance | VMH 30/36 SERIES | Heat Controller, Inc. |
|
|
|
INDOOR SECTION
1FIT THE INSTALLATION PLATE
NOTE:
The installation plate provided with the machine may differ from appliance to appliance.
(Use wall studs for best anchorage)
Correct orientation of Installation Plate
1.Fit the installation plate horizontally on structural parts of the wall with the appropriate clearance around the installation plate.
2. Drill holes in the wall according to the | 5 inches (120mm) |
|
| ||
wall structure and corresponding | or more from |
|
|
| |
mounting points on the installation | the wall | Ø |
|
|
|
|
|
|
|
| |
|
| 2. |
|
| |
|
|
| 6 |
|
|
plate. If the wall is made of brick, |
|
| ”( |
| |
|
|
| Ø | ||
concrete or the like, drill eight 3/16”(5mm) |
|
|
| 65) |
6 inches (150mm) or more |
|
from the ceiling | Flange |
4.75ft.(1250) |
|
6”(150) |
|
Flange
5.2”(133) |
|
.6”(Ø65) | 12.8”(325) |
| |
Ø2 |
|
5 inches (120mm) from the wall
diameter holes in the wall. Insert Clip |
|
|
|
|
|
|
|
|
|
|
|
| |
1.8”(45) |
| |||||
anchor for appropriate mounting screws. |
| |||||
Pipe hole |
|
3.Fit the installation plate on the wall with eight (8) type “A” screws.
Indoor unit outline | Pipe | ”(45) | |
1.8 | |||
Model A | hole | ||
| |||
|
| ||
4.75ft.(1450) |
|
|
NOTE: Dimensions are in inches (mm) unless otherwise stated.
31.4”(35) . 7 ” Ø(
95)
6.1”155)
3.36ft.(1023) | 7.5”(190) | |
16.84”(426) | 16.6”(422) | |
2.8”(70) | 2.8”(71) | |
0.98”(25) | ||
|
|
|
| 6.9”(174) |
1.25”(32) | 12.5”(318) | 1.25”(32) | 0.79”(20) |
12.5”(318) |
|
Model B
13.4”(340)
2DRILL A HOLE IN THE WALL
1.Determine hole positions according to left and right side of the installation plate. The hole center is obtained by measuring the distance as shown in the diagram above.
2.Drill the piping plate hole with Ø2.55in(65mm)
3.Drill the piping hole at either the right or the left and the hole should be slightly slanted to the outdoor side.
4.Always use wall hole conduit when drilling metal grid, metal plate or the like.
4