Ballast Assembly Replacement Instructions
Model 2LBL8
Ballast assembly can be replaced without the cutting of any wires. Use of a qualified electrician is recom- mended.
WARNING: Turn power off at the fuse or circuit breaker.
1.Remove plastic cover.
2.Remove bulb.
3.Remove five screws attaching reflector to fixture housing.
4.Label wires according to wiring diagram.
5.Remove wire nuts from wires. Retain wire nuts to connect re- placement ballast assembly.
6.Remove two screws and lock washers holding ignitor and ballast in place.
CAUTION: Ballast is held in place by ignitor. Carefully remove the ignitor and the ballast together to avoid personal injury in case the ballast slides out of unit.
7.Dispose of used ballast assembly.
8.Connect the replacement ballast assembly following steps 1 through 6 in reverse order.
| Red |
|
| Photocell | |
|
|
|
| ||
|
|
|
| Socket | |
Black | Lamp |
| White | Black | |
Socket | Black | ||||
Red |
| White | |||
|
|
| Red | White |
|
| Blue | Blue |
|
| |
|
| White |
| ||
|
|
|
| Black | |
| Ballast |
|
|
|
|
|
|
| Ignitor | 120V AC | |
|
|
|
| Input |
Fixture Housing
Ballast
Ignitor
Lock Washer
Ignitor Retention Screw
Reflector
Reflector Screw (x5)