180° Motion Sensor
180° Motion Sensor
Features:
•No wiring required.
•Up to 70 feet sensing range, 180° Coverage.
•Adjustable sensitivity.
•Day/Night or Night only operation.
•Test mode.
•Uses 2 AA batteries.
•Wall or eave mount.
•Controls receivers up to 100 feet (30 m) away.
Select Night or 24 Hour Mode
These motion sensors are able to detect motion day and night or night only. To set the detection mode, remove battery compartment cover by sliding the cover down. Remove batteries if necessary. Slide the DETECT switch to either the DAY/NIGHT or NIGHT ONLY position. Replace battery compartment cover by reversing the above instructions.
Installing Batteries
•Before mounting motion sensor, remove battery compartment cover by sliding the cover down.
Install 2 AA batteries according to polarity markings inside the battery compartment. Replace battery compartment cover by reversing the above instructions.
Detect
Control
| Installing Motion Sensor |
| |
1. | Install motion sensor mounting bracket where motion detection is |
| |
| desired. Attach motion sensor mounting bracket to a sturdy object |
| |
| (i.e. tree, post, house, etc.) using two screws provided. Make |
| |
| sure unit has an unobstructed view. Note: Attach mounting |
| |
| bracket vertically if connecting to a curved surface such as a | ENGLISH | |
| post. | ||
2. | Install motion sensor to mounting bracket. Using a | ||
|
screwdriver, loosen the clamp screw on the mounting bracket. Insert swivel ball mount on motion sensor into mounting bracket socket (Note:You should hear a snap).Aim motion sensor toward area where detection is desired. Tighten clamp screw.
IMPORTANT: The motion sensor must be mounted with the bottom cover facing down in order to maintain water tightness.
| Mounting Bracket |
Mounting |
|
Bracket Socket | Mounting Screw |
Nut
Clamp
Screw
Swivel Ball Mount
Sensor
Installing Motion Sensor
DAY NIGHT
NIGHT ONLY
|
|
|
|
|
|
1 2 3 4 |
| DETECT |
CODES |
|
|
180° Motion Sensor
(Rear View)