Heath Zenith 2LBN2 Final Settings, Least Sensitive, Most Sensitive, change the coverage area

NOTE: If fixture is mounted higher than 8 ft.(2.4 m), aiming the sensor down will reduce coverage distance.

The detector is less sensitive to motion directly towards it.

MotionMotion

DualZone™		Sensor	DualZone™
	Least Sensitive		Most Sensitive
3.	Loosen the clamp screw in the		Clamp
	sensor ball joint and gently		Screw
	rotate the sensor.
4.	Walk through the coverage area		Ball
	noting where you are when the		Joint
	lights turn on. Move the sensor
	head up, down, or sideways to

change the coverage area.	Aim Sensor
	Down for Short
	Coverage

Final Settings

1.Secure the sensor head's aim by tightening the clamp

screw. Do not overtighten
the screw.	Aim Sensor Higher
2. Adjust the RANGE as
needed. RANGE set too	for Long Coverage
high may increase false
triggering.

3.Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 20 minutes).

4.Set the DualBrite® switch to the amount of time af- ter dusk you want the lights on at low level (Off, 3, 6 Hrs., Dusk-to-Dawn). Selecting OFF defeats only the dim mode. If motion is sensed, the light turns on full bright for the ON-TIME (1, 5, or 20 minutes) then returns to dim mode.

WARNING: Risk of fire. Do not aim the bulbs at a combustible surface within 3 ft. (1 m).

- - 598-1114-04