Heath Zenith 2LBN2 Troubleshooting Guide, Year limited warranty, Symptom, Possible Cause

TROUBLESHOOTING GUIDE

SYMPTOM	POSSIBLE CAUSE		SOLUTION
Light will not come on.	1.	Light switch is turned off.	1.	Turn light switch on.
	2.	Flood lamp is loose or burned out.	2.	Check flood lamp and replace if burned out.
	3.	Fuse is blown or circuit breaker is turned off.	3.	Replace fuse or turn circuit breaker on.
	4.	Daylight turn-off is in effect.	4.	Recheck after dark.
	5.	Incorrect circuit wiring, if this is a new installation.	5.	Verify wiring is correct.
	6.	Sensor does not detect objects in desired area.	6.	Re-aim sensor to cover desired area. Increase sen-
				sitivity.
Light comes on in day-	1.	Light control may be installed in a relatively dark	1.	Relocate light fixture to another junction box with
light.		location.		increased amount of daylight.
	2.	Light control is in TEST.	2.	Set control switch to 1, 5, or 10 minutes.
Light comes on for no	1.	Light control may be sensing small animals or auto-	1.	Re-aim light control.
apparent reason.		mobile traffic.
	2.	Range is set too high.	2.	Reduce range. Turn Range Boost off.
	3.	DualBrite® timer is on.	3.	Turn DualBrite® Timer off.
Light turns off too late in	Light control may be installed in a relatively dark loca-		Relocate light control, or use 3 hr. or 6 hr. setting.
Dusk-to-Dawn setting.	tion.
Light stays on continu-	1.	A flood lamp is positioned too close to the light control	1.	Reposition the flood lamp away from the light control
ously.		or pointed at nearby objects that cause heat to trigger		or nearby objects.
		the light control.
	2.	The light control may be picking up a heat source	2.	Reduce range. Re-aim sensor. Turn Range Boost
		like an air vent, dryer vent, or brightly painted, heat-		off.
		reflective surface.
	3.	Light control is in manual mode.	3.	Switch light control to AUTO.
Light flashes on and	1.	Heat or light from the flood lamp may be turning the	1.	Reposition the flood lamp away from the light con-
off.		light control on and off.		trol.
	2.	Heat being reflected from other objects may be turn-	2.	Reposition light control.
		ing the light control on and off.
	3.	Light control is in the TEST mode and warming up.	3.	Flashing is normal under these conditions.
Light flashes once, then	Light control is detecting its own light.		Reposition flood lamp to keep area below the light
stays off in manual			control relatively dark.
mode.

1 Year limited warranty:

Should this product fail to perform satisfactorily due to a defect or poor workmanship within one year of date of purchase, return it to the place of purchase and it will be replaced, free of charge. Incidental or consequential damages are excluded from this warranty. Light bulbs are not covered.

Manufactured for Grainger International, Inc.	- -
Lake Forest, IL 60045