TEST AND ADJUSTMENT
❒Turn on the circuit breaker and light switch.NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion.When first turned on or when switching modes wait 1 1/2 minutes.
❒Turn the RANGE control to the medium position (halfway between MIN and MAX), DualBrite® to OFF, and the
LAMP MODE
NORMAL SOFT FLASH
|
|
|
|
| DUAL BRITE™ | ||||||||||
MIN |
|
|
| MAX |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
TEST 1 5 20 | OFF 3 6 DUSK TO | ||||||||||||||
RANGE |
|
|
| MINUTES |
| HOUR DAWN |
Bottom of Sensor
Avoid aiming the sensor at:•Objects that change temperature rapidly, such as heat- ing vents and air conditioners. These heat sources could cause false triggering.
•Areas where pets or unwanted traffic may trigger the control.
•Nearby
270°
8 ft.
(2.4 m)
70 ft. | 100 ft. |
|
(21 m) | (30.5 m) |
|
| Boosted |
|
Maximum Range | Maximum |
Coverage Angle
NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming the sensor down will reduce coverage distance.
The detector is less sensitive to motion directly towards it.
❒ Loosen the clamp screw in the | Clamp | |
sensor ball joint and gently rotate | ||
Screw | ||
the sensor. | ||
| ||
❒ Walk through the coverage area | Ball | |
noting where you are when the | ||
Joint | ||
lights turn on. Move the sensor | ||
| ||
head up, down, or sideways to |
| |
change the coverage area.Keep |
| |
the sensor at least 1" (2.5 cm) |
| |
away from the lamps. | Aim Sensor | |
❒ Adjust the RANGE as needed. | Down for Short | |
RANGE set too high may | Coverage | |
increase false triggering. |
|
❒Secure the sensor head's aim by tightening the clamp screw.
Do not overtighten the screw. ❒ Set the amount ofTIME you want
the lights to stay on after motion is detected (1, 5, or 20 minutes).
❒Set the DualBrite® switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs.,
❒Set the LAMP MODE switch to the desired light turn- on effect (Normal, Soft, Flash).
SPECIFICATIONS
Range . . . . . . . Up to 70 ft. (21 m); 100 ft. (30.5 m) with Range Boost.[varies with surrounding temperature]
Sensing Angle. . . . Up to 270°
Electrical Load. . . . Up to 300 Watts Maximum Incan- descent
Power Requirements. 120 VAC, 60 Hz
Operating Modes. . . TEST, AUTO and MANUAL MODE
Lamp Modes. . . . Normal, Soft, Flash Time Delay . . . . . 1, 5, 20 minutes
DualBrite® Timer. . . Off, 3, 6 hours,
HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
MotionMotion
| Sensor |
Least Sensitive | Most Sensitive |