Heath Zenith 595-5684-08 manual Tune Settings

Tune Settings

Your wireless chime has different selectable tunes: Ding (one note), Ding-Dong(two note), or Westminster (eight note) (Available on selected chimes). The factory setting is for the Ding-Dong tune (or Westminster, when available). This tune can be changed by following the instructions below.

•Ding (one note tune)

Push Button: Add a jumper to location 8.

•Ding-Dong(two note tune)

Push Button: Remove jumper from location 8.

Chime: Remove jumper from location 8.

•Westminster (Eight note tune) (Available on selected chimes) Push Button: Remove jumper from location 8.

Chime: Add a jumper to location 8.

Note: All models have both front and back door tune capabilities.We recommend the back door use the Ding tune and the front door use the Ding-Dongtune (or Westminster tune, available on selected chimes). Models that include two push buttons will come factory set for front and back doors. Decals on the rear of the push button will indicate its setting.

Remove screw to open access door

Back of

Push Button Battery Replacement

Install an alkaline type A23 12 Volt battery. The positive terminal should be positioned as shown.

Chime

12345678

Tune Setting (Not used on all models)

12345678

Inside Push

Button

*Code Settings 1-7 Must Match Both Push Button and Chime

Tune Setting

Note: Some models might require the use of tweezers to remove and replace the jumpers.

595-5684-08 - -