Heath Zenith 598-1119-07 manual Features, Button Remote Control, Operation, Battery Replacement

Remote Controlled Products

Features

•Quickly add ON/OFF control of a receptacle without the expense of new wiring.

•Four selectable channels allowing the use of up to four separate systems in the same home.

•Products are UL/cUL and/or FCC/IC tested and approved.

•Operational range of up to 50 feet.

This manual applies to the following products:

OFF

ON

2-Button Remote Control Indoor/Outdoor Receiver Indoor Plug-In Receiver

2-Button Remote Control

OFF

ON

Operation

1.The two buttons on the remote will operate one or more receiver units with matching channels.

Note: Receivers must be at least 10 feet apart for best performance.

2.Push the ON button to turn the plugged in receiver on or the OFF button to turn the plugged in receiver off.

3.Gently insert a small flat-head screwdriver between the two halves on the bottom of the remote and twist.Carefully separate the back of the remote from the front.

4.Lift the back of the remote up and lay aside.

5.Remove battery. Install replacement battery. Make sure battery is oriented properly (see illustration).

6.Reassemble remote in reverse order.

Battery Replacement

The remote control requires a type A23 12 Volt alkaline battery to operate. The remote control is shipped with the battery installed. With typical use, the battery will last approximately one year. Remove battery when remote will not be used for an extended period of time.

To replace the battery, follow the instructions below:

1.Place remote control face down on a flat surface.

2.Remove screw on bottom of remote with a small phillips-head screwdriver.

Philips-Head	Remote
Screw	Control Back

Flat-Head

Screwdriver

Removing Back of Remote Control

	Battery
ON	Compartment
1 2	(Type A23)

12 V

Inside of Remote Control

© 2007 HeathCo LLC 598-1119-07