OPTIONAL WIRING
❒When wiring to additional standard fixture only: Strip the motion sensor's red wire and connect to the standard light's black wire. Connect all white wires together. Total fixture ratings must not exceed 500 Watts (4.1 A.).
Note: All wiring between fixtures should be run in accordance with the National Electrical Code through conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of the system.
❒This fixture is provided with a sensor rated for 500 Watts. Since the fixture is only rated 100 Watts, 400 Watts of additional load may be controlled by this sensor.
❒When determining what a fixture is rated for, do not simply look at the rating on the lamp in the fixture. Look at the marking which specifies the maximum lamp watt- age for which the fixture is suitable.
❒Once you have selected the fixtures to be connected and determined their maximum ratings, add these ratings up.For instance, if you have 3 fixtures rated 100 Watts, 150 Watts, and 75Watts respectively, you have a total load of 325 Watts.
BLACK | BLACK |
RED | |
WHITE | (Standard) |
|
Wiring to Motion Light &
Standard Fixture
Master | Slave |
| |
BLACK |
|
RED |
|
BLACK |
|
WHITE |
|
Wiring to Control One Motion Sensing Lantern (Slave) from Another (Master)
It is also possible to wire two motion sensing coach lights so that either unit will turn on both lights at the same time (dual master system). It is recommended that only people with plenty of electrical experience attempt this configuration. Please call our customer service number
