Mode Switching Summary

TEST ON-TIME Switch at 1, 5, or 10 minutes

AUTO

Flip light switch off for one sec-

MANUAL MODE ond then back on*

*If you get confused while switching modes, turn the power off for 1 1/2 minutes, then back on. After the calibration time the control will be in the AUTO mode.

DualBrite® Two-Level Lighting

INSTALLATION

For best performance, mount the fixture about 6 feet (1.8 m) above the ground.

WARNING: Turn power off at circuit breaker or fuse.

 

 

 

2. Remove

1.

Remove

 

Mounting Plate.

two nuts.

 

 

 

 

 

 

 

Light comes on at a reduced light level (accent) for selected time after dusk (Off, 3 hr., 6 hr., until dawn). If motion is sensed, the light turns on full bright for the ON-TIME (1, 5, or 10 minutes) then returns to the accent light level.

Bulb Saver Technology

When motion is detected, bulb saver brightens

SENS

MIN MAX

3.Tighten screws finger tight.

Ground Screw

bulb in under 2 seconds. This technology increases bulb life (up to four times) and provides a warmer welcome for guests. The bulb saver feature works with or without the DualBrite® feature activated. The bulb saver feature works automatically - no user adjustment is required.

4.Set sensitivity con-

trol on back of fixture to mid-position.

5. Attach mounting plate to junction box.

Wire Path

598-1283-00

Page 2
Image 2
Heath Zenith 598-1283-00 warranty Installation, DualBrite Two-Level Lighting, Bulb Saver Technology