Mode Switching Summary
| TEST |
|
| ||||
| |||||||
|
|
|
| ||||
|
|
|
|
|
|
| or 10 minutes |
| AUTO |
|
|
|
|
| Flip light switch |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| off for one second |
MANUAL MODE |
|
|
| then back on* | |||
|
|
| |||||
*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.
INSTALLATION
Estimated Installation Time: 30 minutes Items needed for installation (not included):
• | Phillips and flathead screwdrivers | |
• | Pliers | • Wire strippers/cutters |
• | Safety glasses | • Light bulb |
• | Silicone caulk |
|
For best performance, mount the fixture about 6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit breaker or fuse.
This fixture comes with a universal mounting bracket. It is
1.Remove the fixture mounting screws from the mounting plate. Note: Do not remove the ground screw.
2.Attach ground wire “pigtail” to ground screw on mounting plate (See Recommended Grounding Method for additional information).
3.Flip the mounting plate over.
4.Rotate the mounting plate so the wire path is on the upper right. Note: The wire path on the mounting plate must be located as shown below to allow the wires on the back of the fixture to pass through.
5.Reinstall the fixture mounting screws and attach the mounting plate to the junction box as shown.
Wire Path |
| Wire Path |
|
|
|
| Ground Screw |
1.Remove two nuts.
2.Remove Mounting Plate.
3.Tighten screws finger tight.
Fixture Screws
Wire Path
Ground Screw
4.Attach mounting plate to junction box.
As Shipped | Flipped and |
| Rotated |
