Heath Zenith PF-4150-PB, PF-4150-SC, PF-4150-BK, PF-4162-PB Specifications, Troubleshooting Guide

SPECIFICATIONS

Range	. Up to 30 ft. (9.1 m)
	[varies with surrounding
	temperature].
Sensing Angle. . . Up to 150°
Electrical Load. .	. U p	t o	1 0 0	Wa t t
	Maximum Tungsten
	Incandescent
Sensor Capacity . . Up		to 500 Watt (4.1
	A.) Maximum Tungsten
	Incandescent
Power Requirements..... 120 VAC, 60 Hz
Operating Modes. . TEST,			AUTO,	and
	MANUAL MODE
Time Delay . . .	. 1, 5, 10 minutes

HeathCo LLC reserves the right to discon- tinue products and to change specifications at any time without incurring any obligation to incorporate new features in products pre- viously sold.

TROUBLESHOOTING GUIDE

SYMPTOM	POSSIBLE CAUSE
Light will not	1.	Light switch is turned off.
come on.	2. Bulb is loose or burned out.
	3.	Fuse is blown or circuit breaker
		is turned off.
	4.	Daylight turn-off is in effect
		(recheck after dark).
	5.	Incorrect circuit wiring, if this
		is a new installation.
	6.	Re-aim the sensor to cover
		desired area.
Light comes on	1. Light control may be installed
in daylight.		in a relatively dark location.
	2.	Light control is in Test. (Set
		control switch to an ON-TIME
		position.)
Light comes on	1.	Light control may be sensing
for no apparent		small animals or automobile
reason.		traffic (re-aim sensor).
	2.	Sensitivity is set too high.
		(Reduce sensitivity.)

SYMPTOM	POSSIBLE CAUSE
Light stays on	1. The sensor is pointed toward
continuously.		a heat source like an air vent,
		dryer vent, or brightly-painted
		heat-reflective surface.(Re-aim
		sensor.)
	2.	Light control is in Manual Mode.
		(Switch to Auto.)
	3.	Sensitivity is set too high.
		(Reduce sensitivity.)
Light flashes	1.	Heat being reflected from other
on and off.		objects may be affecting the
		sensor. (Re-aim sensor.)
	2.	Light control is in the Test
		mode and war ming up
		(flashing is normal under these
		conditions).

598-1165-05