Wire the Light Control | Mount the Light Control |
WARNING:Turn power off at the fuse or circuit breaker.
❒Remove the existing light fixture.
❒Route the light control’s wires through the large gasket hole.
❒Connect the junction box wires to the light control wires. Twist together and secure with a wire connector.
White to White | Gasket |
❒Align the light control cover plate and the junction box holes. Secure with the mounting screws.
❒If not installed on a weatherproof box or if an adaptor plate (not included) was used, caulk the wall plate and mounting surface with silicone.
Avoid water damage and electrical shock - keep lamp holders below horizontal.
Lock nuts
Keep lamps at least 1" (25 mm) from the sensor.
❒ Adjust the lamp holders by loosening the lock nuts but do not rotate the lamp holders more than 180° from the factory setting.When screwing in the flood- lamps, do not overtighten.
