Heath Zenith manual Motion Sensor Decorative Lighting Control, Operation, Model SL-5210, Test

Motion Sensor

Decorative Lighting

Control

Model SL-5210

Features

• Turns on lighting when motion is detected.

OPERATION

Mode:	On-Time:	Works:	Day	Night
Test	5 Sec		x	x
Normal	1, 5, 10 min.			x
Manual	Until Dawn*			x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 11/2 minutes for the circuitry to calibrate.

TEST

Put the ON-TIME switch on the bottom of the ON-TIME

• Automatically turns lighting off.

• Photocell keeps the lighting off during daylight hours.

Requirements

•The light control requires 120-volts AC.

•If you want to use Manual Override, the control must be wired through a wall switch.

•Some codes require installation by a qualified electrician.

•Switch Module mounts into a standard 4" x 4" junction box.

sensor in the TEST position.

AUTO

Put the ON-TIME switch in the 1, 5, or 10 minute position.

MANUAL MODE

10 5 1 TEST

ON-TIME

10 5 1 TEST

The SL-5210 package includes:

•The Sensor Module and Switch Module

•Three wire nuts

•Two sensor module screws

Typical Installation

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second
then back on to toggle between AUTO and	1 Second OFF
MANUAL MODE.	then...

Switch Mod-

ule In Junction

Box Behind Light Fixture

Existing Light Fixture

Sensor Cord

Sensor Module

Drip Loop

Manual mode works only with the ON-TIME
switch in the 1, 5, or 10 position.
		... back on.
	Mode Switching Summary
	TEST	Move ON-TIME Switch to 1,
		5, or 10 minutes

AUTO Flip switch off for one second then back on*MANUAL MODE

NOTE: The Drip Loop is neccessary to prevent rain from running down the cord to the Sensor Module.

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time (11/2 min.) the control will be in the AUTO mode.

© 2007 HeathCo LLC 595-4991-07