Heath Zenith SL-5309 manual Motion Sensor Quartz Security Light, Operation, Installation, On-Time

Motion Sensor Quartz Security Light

Model SL-5309

The Motion Sensor Quartz Security Light turns on 300 watts of quartz-halogen lighting when motion is detected and then, after a selectable period of time, automati-

TEST

Put the ON-TIME switch on the bottom	ON-TIME
of the sensor in the TEST position.
	10 5 1 TEST
AUTO
Put the ON-TIME switch in the 1, 5, or	ON-TIME
10 minute position.
	10 5 1 TEST
MANUAL MODE

cally turns the lighting off. The built-in photocell keeps the lighting off during daylight hours.

This package includes:

Cover Plate

Gasket

Cover
	4 Screws
Plate
	(2 sizes)

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1 Second OFF

then...

... back on.

	Halogen
	Bulb
	Sensor
		3 Wire
Light Control	Long Bolt	Connectors

Requirements

•The light control requires 120-volts AC.

•If you want to use Manual Mode, the control must be wired through a switch – not a dimmer or other electronic switch.

•Some codes require installation by a qualified electrician.

•This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.

•The backplate has knockouts so the sensor can be mounted on most junction boxes.

•In some applications a universal adaptor plate may be needed. Adaptors are available at Home Centers and Electrical Supply Stores.

OPERATION

Mode:	On-Time	Works: Day	Night
Test	5 Seconds	x	x
Auto	1, 5, or 10 Min		x
Manual	Until Dawn*		x

* resets to Auto Mode at dawn.

Mode Switching Summary

	TEST	Move ON-TIME Switch
			to 1, 5, or 10 minutes
	AUTO			Flip switch off for
				one second then
MANUAL MODE				back on*

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time (1 1/2 min.) the control will be in the AUTO mode.

INSTALLATION

For easy installation, select an existing light with a wall switch for replacement.

❒ Attach the lamp arm to the backplate arm and secure with the long bolt.

Note: When tightening the arm screw, pull on the wires to make sure the wires are not pinched by the joint.

© 2007 HeathCo LLC 595-5496-07