❒ Drill out the holes if needed to mount the backplate to the junction box.
Wire the Light Control
WARNING: Turn power off at circuit breaker or fuse.
❒Remove the existing light fixture.
❒Strip about 5/8" (16 mm) insulation from the existing junction box wiring.
❒Route the light control’s wires through the large hole in the gasket.
❒Twist the junction box wires and fixture wires together as shown. Secure with a wire connector.
Black to Black |
White to White |
Cover Plate Gasket
Junction box ground wire to green ground wire on fixture.
Mount the Light Control
For proper operation and safety, the light fixture must be above the sensor.
❒Align the light control cover plate and cover plate gasket and the junction box. Insert and tighten the mounting screws.
❒If not installed on a weatherproof box or if an adaptor plate is used, caulk the wall plate and mounting surface with silicone weather sealant.
RIGHTWRONG
The halogen light must be mounted horizontally (+/- 4°).
Bulb Installation And Relamping
❒When
CAUTION to avoid fire or burn hazards:
•Allow fixture to cool before touching. The bulb and fixture operate at high temperatures.
•Keepfixtureatleast2"(51mm)fromcombustiblemateri- als. Do not aim at objects closer than 3 feet (1 m).
•
❒Remove glass cover and remove the old bulb by pushing the bulb towards the right until the left side of the bulb is clear of the left socket.
❒To insert the new bulb, push the bulb into the right socket so the bulb fits completely into the left socket.
❒Check that the bulb is seated properly.
❒
For under eave installation, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock.
For eave mount only:
❒Rotate the sensor head towards the clamp screw joint.
Controls
Clamp Screw
❒Then rotate the sensor head clockwise 180° so the controls face down.
Controls 
If the sensor pops out of the ball joint, loosen the clamp screw and push the sensor back into the ball joint. Tighten the clamp screw when done.
