TEST AND ADJUSTMENT
❒Turn on the circuit breaker and light switch.
NOTE: Sensor requires about 1 1/2 minutes to calibrate before it will detect motion. When first turned on, wait about 1 1/2 minutes.
❒Turn the SENSITIVITY (SENS) control to the mid position and the
SENS | |
10 5 1 TEST | MIN MAX |
Bottom of Sensor
Avoid aiming the control at:
❒Loosen the clamp screw in the sensor ball joint and gen- tly rotate the sensor to aim.
❒Walk through the coverage area noting where you are when the lights turn on. Move the sensor head up, down, or sideways to change the coverage area.
❒SetSENSITIVITYasneeded. Too much sensitivity may in- crease false triggering.
❒Secure the sensor head into position by tighten- ing the clamp screw. Do not overtighten the screw.
❒Set the amount of TIME the lights stay on after motion is detected.Itisselectablefrom 1, 5, or 10 minutes.
Clamp
Screw
Ball
Joint
Aim Sensor Down for Short Coverage
Aim Sensor
Higher for Long
Coverage
•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.
•Areas where pets or traffic may trigger the control.
•Nearby large,
| 110° |
8 ft. |
|
(2.4 m) |
|
| 60 ft. |
| (18.3 m) |
Maximum | Maximum |
Range | Coverage Angle |
The control is most sensitive to motion across it.
MotionMotion
Sensor
Least Sensitive | Most Sensitive |
SPECIFICATIONS
Range . . . . . . . . . . . . . Up to 60 ft. (18.3 m); [varies with surrounding temperature]
Sensing Angle . . . . . . . Up to 110°
Electrical Load . . . . . . . Up to 300 Watts Maximum Tungsten
Power Requirements . . 120 VAC, 60 Hz
Operating Modes . . . . . TEST, AUTO and MANUAL
MODE
Time Delay . . . . . . . . . 1, 5 or 10 minutes Sensitivity . . . . . . . . . . Adjustable
Replacement lamp . . . T 300W (or less) halogen 120
VAC
DESA Specialty Products™ reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
3 |
