Bulb Installation
NOTE: Lamps are included, but you will need to install them
NOTE: When
❒Open glass covers. To remove the old bulb push the bulb towards the right until the left side of the bulb is clear of the left socket.
❒To install a bulb, push the bulb into the right socket so the bulb fits completely into the left socket.
❒Check that the bulb is seated properly.
❒Close the glass covers.
Wire the Light Control
WARNING: Turn power off at circuit breaker or fuse.
❒Remove the existing light fixture.
❒Install mounting strap to junction box using screws appropriate for your junction box.
❒The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of the cover plate. The small end then goes into one of the slots on the mounting strap.
❒Thread all fixture wires through the large holes in the gasket as shown.
❒Connect the junction box wires to the light fixture wires as shown. Twist together and secure with wire connectors.
CAUTION: Do not cut any wires with factory installed wire connectors.
White to White
Mounting Strap
Mount the Light Control
❒Place the mounting bolt through the front of the junction box cover. Push the small gasket hole over the mounting bolt.
❒Make sure the wire connectors and wires are inside the junction box. Align the mounting bolt with the center hole in the mounting strap.Secure the fixture to the mounting strap.
❒Push the rubber plug firmly into place.
Mounting Bolt
Rubber Plug
❒If not installed on a weatherproof box, caulk the wall plate and mounting surface with silicone.
❒Adjust the lamp holders by loosening the lock nuts but do not rotate the lamp holders more than 180° from the factory setting.
Push the rubber plug over the mounting bolt.
Gasket
Black to Black
Keep lamps at least 1" (2.5 cm) from the sensor.
Connect green or bare copper wire(s) in the fixture to green ground screw and ground wire in junc- tion box. Note: All ground wires shown as green in above illustration.
