TEST AND ADJUSTMENT
❒Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on or when switching modes wait 1 1/2 minutes.
❒Turn the RANGE control to the mid position, Dual Brite™ to OFF and the
MAX |
|
|
|
|
B | O | ON - TIME | DUAL BRITE | |
| ||||
| O |
|
| |
| T | S |
|
|
MIN |
|
|
| |
| TEST 1 5 2 0 | OFF 3 6 | DUSK TO | |
RANGE |
| |||
| MINUTES | HOUR | DAWN | |
Bottom of Sensor
Avoid aiming the sensor at:
• | Objects that change temperature rapidly, such as |
| heating vents and air conditioners. These heat |
| sources could cause false triggering. |
• | Areas where pets or traffic may trigger the control. |
❒ Loosen the clamp screw in the sensor ball joint and gently ro- tate the sensor.
❒ Walk through the coverage area noting where you are when the lights turn on. Move the sensor head up, down, or sideways to change the coverage area.
Keep the sensor at least 2" (51 mm) away from the lamps.
❒ Adjust the RANGE as needed. Too much range may increase false triggering. Range Boost increases coverage up to 100 feet.
❒Secure the sensor head's aim
by tightening the clamp screw.
Do not overtighten the screw.
❒ Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 20 minutes).
❒Set the DUAL BRITE™ switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs.,
SPECIFICATIONS
• Nearby large, |
may trigger the |
lights at the sensor. |
240°
8 ft.
(2.4 m) 
70 ft. | 100 ft. |
(21 m) | (30.5 m) |
| Boosted |
Maximum | Maximum |
Range | Coverage Angle |
Range . . . . . . . . . . . . . .
Sensing Angle . . . . . . . .
Electrical Load . . . . . . . .
Power Requirements . . .
Operating Modes . . . . . .
Time Delay . . . . . . . . . .
Dual Brite™ Timer . . . . .
Replacement lamp . . . .
Up to 70 ft. (21 m); 100 ft.(30.5 m) with Range Boost. [varies with surrounding temperature]
Up to 240°
Up to 200 Watts Maximum Incandescent (Up to 100 Watts Maximum each lamp holder.)
120 VAC, 60 Hz
TEST, AUTO and MANUAL MODE
1 , 5, 20 minutes
3, 6 hours,
The control is most sensitive to motion across it.
MotionMotion
Sensor
Least Sensitive | Most Sensitive |
DESA Specialty Products™ reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
3 |
