INSTALLATION
For best performance, mount the fixture about 8 feet (2.4 m) above the ground.
Note: Mounting fixture higher than 8 ft. (2.4 m) will reduce coverage distance.
1.Mountsolarpanelbaseonasolidsurfaceusing three tapered screws. Adjust the panel to point directly at the noon sun. Avoid obstructions such as trees or buildings that may block sun light. Allow for enough wire to reach the case.
Keep ball joint at bottom.
Note: You will want to
Mounting Holes (3)
•Level light fixture.
•From inside the battery compartment, mark location of second screw in the mounting hole.
•Remove light and drill one 1/16" pilot hole in second location.
•Hang light on keyhole screw and insert sec- ond screw through mounting hole. Tighten securely.
Keyhole Slot
Mounting Hole
Rear of Light Fixture
Three Mounting Holes for Solar Panel Base
2.Mounting light on a solid, vertical surface (wall) using two
•Determine mounting location.IMPORTANT:
Mount fixture with the light above the sen- sor.
•Open battery com- partment door and
remove batteries and tab. Note: Discard plastic tab.
• Drill one 1/16" pi- lot hole for keyhole mounting screw and insert screw. Note: Leave approximately 1/8" (3 mm) of the screw threads ex- posed.
• Using the keyhole on the back of the light, temporarily hang light fixture on screw.
3.Mounting light on a solid, horizontal surface (eave) using two
•Determine mounting location.IMPORTANT:
Mount fixture with the sensor facing the detection zone.
•Follow the directions for vertical surface mounting to complete installation. Note:
The light fixture will not need to be leveled for horizontal mounting.
Battery | Detection Zone |
| |
Compartment |
|
Door |
|
Eave Mounted Light | |
