Controlling Non-Motion Sensing Fixtures
❒When wiring to additional standard fixture only: Strip the motion sensor's red wire and connect to the standard fixture's black wire. Connect all white wires together. Total fixture ratings must not exceed 1000 Watts (8.3 A).
NOTE: All wiring between fixtures should be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through conduit or another acceptable means.
Contact a qualified electrician if there is any question as to the suitability of the system.
❒This fixture is provided with a sensor rated for 1000 Watts. Since the fixture is only rated 500 Watts, 500 Watts of additional load may be controlled by this sensor.
❒When determining what a fixture is rated for, do not simply look at the rating on the lamp in the fixture. Look at the marking which speci- fies the maximum lamp wattage for which the fixture is suitable.
❒Once you have selected the fixtures to be con- nected and determined their maximum ratings, add these ratings up. For instance, if you have 3 fixtures rated 100 Watts, 150 Watts, and 75 Watts respectively, you have a total load of 325 Watts.
WHITE from Line
to WHITE from Security Light
BLACK from Switch to | RED from Security Light to | |
BLACK from Security Light | ||
BLACK from Fixture | ||
| ||
| Standard | |
| Fixture |
WHITE from Line to
WHITE from Fixture
