Heatiator ADI60S owner manual Log Set Assembly: LOGS-ADI60, F. Positioning the Logs

F. Positioning the Logs Log Set Assembly: LOGS-ADI60

If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the following instructions.

CAUTION: Logs are fragile! Carefully remove the logs from the packaging.

		1
4	6	5	7
	2		3

PILOT

BURNER BASE PAN

1

1

LOG #1 (SRV340-701):Place log #1 in the back on the insert. Locate the legs of the log outside the 3/8” tabs to either side of the burner. Pull the log forward until the log is stopped by the back edge of the burner. The log should be centered.

2

2

LOG #2 (SRV340-702):Position log #2 by locating its slot over the tab on the front left of the burner. The slot in the left end of the log slides into the vertical metal edge in front of the square cut out on the base pan.

22 Heatilator • ADI60S • 345-900 Rev. G • 9/08 345-935 6/02