Clearances | Heatiator ADI60S specification

B. Clearances

WARNING

Fire Risk.

Odor Risk.

• Clearance to combustible material under the insert is 1/4 inch (0.6 cm).

•Use leveling legs to raise insert minimum 1/4 inch above combustible material or outer wrap of factory built ﬁrebox.

WARNING

Fire Risk.

• Locate and install appliance to all clearance speciﬁcations in manual.

INLET AIR	12 in. MAX.
EXHAUST VENT PIPE
VENT PIPE
	MANTEL

12 in. MIN.

MEASUREMENTS FROM

TOP EDGE OF UNIT

Figure 3.2 Clearances to Mantels or other Combustibles above Appliance

Heatilator • ADI60S • 345-900 Rev. G • 9/08

7

Image 7

Heatiator ADI60S owner manual Clearances to Mantels or other Combustibles above Appliance

Contents

What to do if you smell gas ModelHOT Surfaces Xxxxxxxx Homeowner Reference Information Table of Contents Listing and Code Approvals Inspect Appliance and Components Design and Installation ConsiderationsGetting Started Tools and Supplies Needed Minimum Fireplace Opening Fireplace Size RequirementsADI60 Clearances to Mantels or other Combustibles above Appliance Clearances Vent Termination Minimum Clearances Termination Locations Measuring Standards Vent Information and DiagramsVent Table Key Horizontal Venting Installation Preparation Connecting Vent Pipe Installing Vent Pipe and ApplianceVenting Components Placing, Securing and Leveling the Appliance Class a Pipe Installing Adaptor and Termination CapFactory Built Wood Burning Damper Flashing Kit Optional Fuel Conversions Gas Connection Gas InformationGas Pressures Check for GAS Leaks High Altitude Installations Appliance Requirements Wiring the ApplianceON/OFF Switch Electrical Information Optional Accessories Junction Box Installation FAN Junction BOX Mantel Projections Finishing Ember Placement Appliance SetupClean the Appliance Accessories Refractory from the packaging Refractory PlacementModels Supreme-XT, Grand-XT QVI30, QVI35, ADI60 Positioning the Logs Log Set Assembly LOGS-ADI60 Areas for LOG #4 Placement Heatilator ADI60S 345-900 Rev. G 9/08 Replacing Glass Assembly Glass AssemblyAir Shutter Setting Removing Glass Assembly Before Lighting Appliance Operating InstructionsBefore operating this appliance have a qualified technician Standing Pilot Ignition Lighting ApplianceWhat to do if YOU Smell GAS Check Pilot Flame Appearance Initial Break-in ProcedureAfter Appliance is Lit Issue Solutions Frequently Asked Questions Symptom Possible Causes Corrective Action TroubleshootingStanding Pilot Ignition System Symptom Possible Cause Corrective Action Troubleshooting Maintaining and Servicing Appliance Maintenance Tasks Doors, Surrounds Inspect Maintenance Tasks Reference Materials Appliance Dimension Diagram Direct Vent Flex Liner Kits Vent Kits Components Service Parts Log Set AssemblyPart number list on following At Depot Service Parts Stocked Standing Pilot Valve Assembly CONDITIONS, Exclusions & Limitation of Liability Limited Lifetime Warranty Contact Information