3 Maintenance and Service

A. Disposal of Ashes

•Frequency: When ash is within 1-3/4 inch (44mm) of firebox lip. Leave 1/4 to 1/2 inch (6-13mm) of ash in the bottom of the firebox.

•By: Homeowner

WARNING! Risk of Fire! Ashes could contain hot embers.

•Place ashes in a metal container with a tight-fitting lid.

•The closed container should be placed on a non- combustible floor or on the ground, well away from all combustible materials, pending final disposal.

•If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled

B.Chimney and Chimney Connector Inspection/Cleaning

•Frequency: Every 2 months during heating season or as recommended by a certified chimney sweep; more frequently if chimney exceeds or is under 14-16 ft (4.3- 4.8m). (measured from bottom of appliance).

•By: Certified Chimney Sweep

WARNING! Risk of Fire! Ignited creosote is extremely HOT. Prevent creosote buildup.

•Remove all ash from the firebox and extinguish all hot embers before disposal.

•Allow the appliance to cool completely.

•Disconnect flue pipe or remove baffle and ceramic blanket from appliance before cleaning chimney. Otherwise residue can pile up on top of the baffle and ceramic blanket. (See Baffle Removal on page 23).

•Close the door tightly.

•The creosote or soot should be removed with a brush specifically designed for the type of chimney in use.

•Clean out fallen ashes from the firebox.

•It is also recommended that before each heating season the entire system be professionally inspected, cleaned and repaired if necessary.

WARNING! Risk of Fire!

Do not use chimney cleaners or flame colorants in your appliance. It will corrode your pipe.

Creosote - Formation and Need for Removal

•When wood is burned slowly, it produces tar and other organic vapors, which combine with expelled moisture to form creosote.

•The creosote vapors condense in the relatively cool chimney flue of a slow-burning fire.

•As a result, creosote residue accumulates on the flue lining. When ignited this creosote makes an extremely hot fire.

•The chimney and chimney connector shall be inspected every two months during the heating season to determine when a creosote buildup has occurred.

•When creosote has accumulated it shall be removed to reduce the risk of a chimney fire.

C. Appliance Inspection - Routine

•Frequency: Every 2 months at the same time the chim- ney and chimney connector are inspected.

•By: Homeowner

Check for:

•Cracks in glass

•Door handle - smooth cam operation

•Baffle and ceramic blanket correct placement

•Baffle for cracks

•Firebrick for cracks, broken or crumbly

•Door gasket. (Dollar bill test). Place a dollar bill between the stove and the door and then shut the door. If you can pull the dollar bill out, remove one spacing washer from the door handle behind the latch cam and try the test again. See Figure 22.1 on page 22. If you can still pull the dollar bill out, replace the door gasket.

•Glass frame for loose screws

Heatilator • ECO-WINS18 • 7065-132B • August 29 2011

17

Page 16 Page 18
Page 17
Image 17
Heatiator ECO-WINS18 Maintenance and Service, Disposal of Ashes, Chimney and Chimney Connector Inspection/Cleaning
Page 16 Page 18

ECO-WINS18 specifications

The Heatiator ECO-WINS18 is a cutting-edge heating solution designed to elevate warmth and comfort in residential and commercial spaces. This innovative unit embodies modern technology, efficiency, and user-centric design, making it a noteworthy choice for anyone in the market for a reliable heating system.

One of the standout features of the ECO-WINS18 is its advanced energy efficiency. This unit boasts a high efficiency rating, significantly reducing energy consumption while delivering powerful heating capabilities. This translates to lower energy bills and a reduced carbon footprint, aligning with growing environmental consciousness among consumers.

The ECO-WINS18 employs a dual heating system that includes both convection and radiant heat technologies. This hybrid approach ensures rapid heat distribution throughout the room, providing consistent warmth while eliminating cold spots. The convection component circulates warm air, while the radiant heat warms objects and surfaces directly, creating a cozy atmosphere.

User convenience is a priority in the design of the ECO-WINS18. It comes equipped with a user-friendly digital thermostat that allows precise temperature control with ease. Additionally, the unit features programmable settings, enabling users to customize heating schedules to suit their lifestyle. This not only enhances comfort but also promotes energy savings.

Safety is a critical consideration in any heating appliance, and the ECO-WINS18 excels in this area as well. It includes multiple safety features such as overheat protection and a tip-over switch that automatically shuts the unit down if it is accidentally knocked over. This ensures peace of mind for users, especially in homes with children and pets.

The sleek and modern design of the ECO-WINS18 allows it to blend seamlessly with various decors, making it an aesthetic addition to any room. The compact size of the unit makes it easy to install, and it can be used as a standalone piece or integrated with existing heating systems.

In summary, the Heatiator ECO-WINS18 stands out for its superior energy efficiency, dual heating technology, user-friendly controls, and safety features. Its modern design not only enhances interior aesthetics but also offers practical functionality. For those seeking an effective and reliable heating solution, the ECO-WINS18 is a wise investment that promises comfort and efficiency for years to come.
Top Page Image Contents