Henny Penny 322, 324, 323 installation instructions Per Well

Models: 323 322 324

1 11
Download 11 pages 59.25 Kb
Page 7
Image 7
(Per Well)

Model OFE/OFG-321,322,323,324

2-9. ELECTRICAL REQUIREMENTS OFG-320 SERIES (Continued)

2-10. ELECTRICAL REQUIREMENTS OFE-320 SERIES

DRYWALL CONSTRUCTION Secure I-bolt to a building stud. Do not attach to drywall only. Preferred installation is approximately six inches to either side of service. Cable restraint must be at least six inches shorter than flexible conduit.

2-7

To avoid electrical shock, do not disconnect the ground (earth) plug. This fryer must be adequately and safely grounded (earthed). Refer to local electrical codes for correct grounding (earthing) procedures or in absence of local codes, with The National Electrical Code, ANSI/NFPA No. 70-(the current edition). In Canada, all electrical connections are to be made in accordance with CSA C22.1, Canadian Electrical Code Part 1, and/or local codes.

Refer to the table below for supply wiring and fusing.

 

 

(Per Well)

 

Volts

Phase

Kw

Amps

200-208

3

14.4

40

220/240

3

14.4

40

440-480

3

14.4

17

380-415

3

14.4

20

To avoid electrical shock, this appliance must be equipped with an external circuit breaker which will disconnect all ungrounded (unearthed) conductors. The main power switch on this appliance does not disconnect all line conductors.

To avoid electrical shock, this fryer must be adequately and safely grounded (earthed). Refer to local electrical codes for correct grounding (earthing) procedures or in absence of local codes, with The National Electrical Code, ANSI/NFPA No. 70-(the current edition). In Canada, all electrical connections are to be made in accordance with CSA C22.1, Canadian Electrical Code Part 1, and/or local codes.

CE units require a minimum wire size of 6 mm to be wired to the terminal block.

Permanently connected electric fryers with casters must be installed with flexible conduit and a cable restraint, when installed in the United States. See illustration at left. Holes are available in the rear fryer frame for securing the cable restraint to the fryer. The cable restraint does not prevent the fryer from tipping.

705

Page 7
Image 7
Henny Penny 322, 324, 323 installation instructions Per Well