Henny Penny 323, 324, 322 installation instructions Testing The Fryer, Joining Instructions

Model OFE/OFG-321,322,323,324

2-11. TESTING THE FRYER	Each Henny Penny pressure fryer was completely checked
	and tested prior to shipment. However, it is good practice to
	check the unit for proper operation.
2-12. JOINING INSTRUCTIONS	The following instructions are for joining two units together.
	The instructions have part numbers in them. Please refer to
	figure 2-1 on the following page to visually match the
	numbers in the instructions below to the illustration.
	1.	Remove all hardware from the sides of the two open
		fryers.
	2.	Remove the right control panel assembly from the left
		unit and the left control panel assembly from the right
		unit.
	3.	Move the two units side by side with minimal gap.
	4.	Remove the right front caster from the left unit and the
		left rear caster from the right unit. Fasten both casters to
		the rear of the unit with wire ties (EF02-041).
	5.	Position the two open fryers by inserting bolts
		(SC01-227) thru the holes in top cover and the pot sides.
		Use washer (WA01-017) on both sides of the bolt when
		installing. DO NOT TIGHTEN!
	6.	Position front spacer (60554) between the front of the
		two open fryers. Place bolt (SC01-231), backed by
		washers (55350 & WA01-016), thru three holes in the
		frame capturing the spacer between the frames. Place
		washers
		(55350 & WA01-016) on bolt before installing nuts
		(NS02-010). DO NOT TIGHTEN!
	7.	Repeat with rear spacer (60555).
	8.	Tighten all fasteners securely.
	9.	Place cover (60593) over gap between open fryers.
	10.	Drill out dimples on rear shroud to 0.250 diameter holes.
	11.	Apply silicon around edge of unfinished side of rear
		cover (60599). Install rear cover (60599) with #8 nuts
		(NS02-007).
211		2-8