Henny Penny CBC/CBR-105, CBC/CBR-106, CBC/CBR-104, CBC/CBR-107, CBC/CBR-103 manual Operation

Model CBC/CBR-103,104,105,106,107

SECTION 3. OPERATION

3-1. INTRODUCTIONThis section provides explanations of all controls, along with operating procedures and daily maintenance. Read the Introduction, Installation and Operation Sections before operating the unit.

			Wait at least 4 hours before plugging the unit into an
			electrical supply. The gases and oils in the refrigeration
			system need to settle before operating the compressor, or
			damage to the compressor could result.
3-2.	OPERATING CONTROLS		Refer to figure 3-1.
Fig.	Item	Description	Function
No.	No.
3-1	1	Power Switch	A rocker switch that turns electrical power off and on to
			the unit; located on the bottom of the control panel
3-1	2	DigitalDisplay	Shows the temperatures and the information in the Technical
			Mode
3-1	3		The up and defrost button is used to increase setpoint
			values, as well as programming values; also, automatic
			defrost cycles are programmed in the controls, but to
			manually start a defrost cycle, press and hold			for 3
			seconds to start a manual defrost cycle
			(“DEF/SET’ shows in display)
3-1	4		The down button is used to decrease setpoint values, as
			well as programming values
3-1	5		Press the set button to view the setpoint temperature, or
			hold it for it for 4 seconds to enter the Program Mode;
			once in the Program Mode, press		to view other
			parameter setpoints; press	, along with		and
			to change the parameters.

3-1 303