Henny Penny CBC/CBR-105, CBC/CBR-106, CBC/CBR-104, CBC/CBR-107, CBC/CBR-103 manual Programming

	Model CBC/CBR-103,104,105,106,107
3-5. PROGRAMMING	dS: (defrost system (computation)) dF=digifrost feature;
Continued	defrost start time based on total compressor running time.

rt=real time; defrost start frequency, based on real time

dI: (defrost interval) defrost frequency in hours, based on the selection of “dS”

dE: (defrost endurance) total (maximum) length of a defrost cycle, expressed in minutes. (1...99 range)

dL: (display lock) temperature display is locked during a defrost cycle. (0...31 range)

“n”=no (readout continues to display the actual tempera- ture, even during a defrost cycle

“y”=yes (readout is locked)

dr: (display read-out) select the type of visualization in case of temperature display lock during defrost (see prameter dL) “C”=the temperature displayed at the start of a defrost is

locked and does not change during this cycle “dF”=during the defrost “dF” is displayed

do: (defrost at power on) selects whether or not, the system goes through the defrost cycle at start-up (or after power failure)

“n”=no

“y”=yes

dd:(defrost delay at power on) delay of defrost cycle, in minutes. (0...99 range)

Error Code “E1”

This is the only error code in these controls. It indicates a tempera- ture sensor failure, such as, a shorted sensor, a sensor break, or absence of sensor.

It can also indicate an under-range in the system temperature (-55).

In case of an over-range in the system temperature, “99” shows first in the display, followed by “E1”.

303 3-6