Henny Penny | Model |
SECTION 3. OPERATION
Wait at least 4 hours before plugging the unit into an electrical supply. The gases and oils in the refrigeration system needs to settle before operating the compressor, or damage to the compressor could result.
3-2. OPERATING CONTROLS Refer to figure 3-1.
Fig. | Item | Description |
|
| Function |
|
|
No. | No. |
|
|
|
|
|
|
1 | Power Switch | Turns electrical power off and on to the unit; located on the | |||||
|
|
| bottom of the control panel |
|
| ||
2 | DigitalDisplay | Shows the temperatures and the information in the Technical | |||||
|
|
| Mode |
|
|
|
|
3 |
| Used to increase setpoint values, as well as programming | |||||
|
|
| values; also, automatic defrost cycles are programmed in | ||||
|
|
| the controls, but to manually start a defrost cycle, press and | ||||
|
|
| hold | for 3 seconds to start a manual defrost cycle; | |||
|
|
| “DEF/SET’ shows in display |
|
| ||
4 |
| Used to decrease setpoint values, as well as programming | |||||
|
|
| values |
|
|
|
|
5 |
| Press to view the setpoint temperature, or hold it for it for 4 | |||||
|
|
| seconds to enter the program mode; once in the Program | ||||
|
|
| Mode, press | to view other parameter setpoints; | |||
|
|
| Press |
| , along with | and | to change the |
|
|
| parameters |
|
|
|
303 |