7 Additional information

It’s often easy to mistake incorrect operation for trouble and malfunction of the unit. If you think there is something wrong with the component, check the points below first. If the problem persists, contact you nearest HHB authorized service center and have them check over the unit.

Symptom

Cause

Remedy

 

 

 

 

 

Power cannot be

The power cord is unplugged from the wall

Plug the power cord into a

 

turned on.

outlet.

power outlet.

 

 

The power plug is not firmly connected to

Make sure that the power plug is

 

 

the recorder.

fully inserted in the recorder.

 

 

 

 

 

No sound is heard

The recorder is not connected up properly.

Check all connections, especially

 

during playback.

 

to the amplifier (p.10–11).

 

 

 

 

 

Cannot record.

The recorder is not connected up properly.

Check all connections (p.10–11)

 

 

The CD-R or CD-RW disc in use has already

Use a non-finalized disc or erase

 

 

been finalized.

the CD-RW disc (p.38).

 

 

The input selection is incorrect.

Select the input for the correct

 

 

 

input source to the recorder.

 

 

The REC LEVEL control is set too low.

Increase the recording level

 

 

 

(p.23–24).

 

 

 

 

 

Recorded sound is

The REC LEVEL control is set too high.

Reduce the recording level (p.23

 

distorted.

 

–24).

 

 

Signal connections are incorrect.

Check all connections (p.10–11)

 

 

There is interference from external

Turn the power off to other units

 

 

sources.

near the recorder until there is no

 

 

 

interference.

 

 

The disc is damaged or warped.

Use another disc.

 

 

The disc is extremely dirty.

Clean the disc.

 

 

 

 

 

Remote control

The remote control batteries are

Replace both of the remote

 

operation is

exhausted.

control batteries with new ones.

 

impossible.

There is an obstacle between the remote

Remove the obstacle.

 

 

 

 

control unit and main unit.

 

 

 

The remote control unit is being operated

Operate in the remote

 

 

outside the remote controllable range.

controllable range (p.9).

 

 

 

 

 

Some tracks are

The SKIP PLAY button is set to on.

Set the SKIP PLAY button to off

 

skipped without

 

(p.28).

 

being played.

 

 

 

 

 

 

 

Skip playback does

The SKIP PLAY button is set to off.

Set the SKIP PLAY button to on

 

not occur.

 

(p.28).

 

 

 

 

 

The recorder does

The level that the recorder regards as

Set the silence threshold to a

 

not recognize the

‘silence’ is set either too low, or too high.

suitable level for automatically

 

end of tracks

 

numbering tracks (p.33).

 

during sync

 

 

 

recording.

 

 

 

 

 

 

 

A recorded CD-R

The disc has not been finalized after

Finalize the disc (p.26).

 

disc cannot be

recording. When such a disc is loaded, the

 

 

played on other CD

CD-R indicator lights up.

Try the disc on a different CD

 

players.

The pickup lens of the other CD player is

 

dirty, impairing its ability to play CD-R discs.

player. If it plays OK then get the

 

 

 

 

 

pickup lens on the original player

 

 

 

cleaned.

 

42