Hill Phoenix KRZH manual Line Up Trim Out

LINE UP &

TRIM OUT

Now that cases have been positioned and leveled, you may proceed to trim-out case lineup. Trim parts have been designed to be applied easily with only a small number of fasteners required. Most external parts are adjustable to achieve almost invisible, snug-fitting joints and a high level of excellence in fit and finish.

Consult With General Contractor

Ask the general1contractor if there have been changes in the building dimen- sions since the print you are using was issued. Also, ask the points of reference from which you should take dimensions to locate the cases.

BASE RAIL BASE RAIL

Snap Chalk Lines	S n a p L i n e s		O n	B a s e	R a i l	Level Floor. Use Laser Transit
	Locations
Mark floor where cases are to be	Snap lines where base rails are posi-					Leveling is necessary to assure proper
located for the entire lineup.	tioned, not the front or back edges of					case alignment. Locate highest point on
	the cases. See		case	cross	section	chalk	line	as	reference	for
	drawing, page 3, for rail location dimen-					determining height of shim-pack
2	sions.	3				levelers.	A laser transit is recommend-
						ed for precision.4

Set Shims On Basehorse Locations		Position First Case In Lineup,	Position Next Case In Line Up
	5	Remove Casters, Level	them.	7
		6
Locate basehorse positions along chalk		Roll first case into position. Raise case	Roll case approximately 6’ from adjoin-
lines.	Spot shim packs at each	from end under cross support using	ing case. Remove casters on the end
basehorse location.		“J” bar. Remove cotter pins, casters,	nearest to the next case. Allow casters
		and outriggers. [CAUTION! Keep hands	to remain on opposite end to assist in
		from under case] Level case on shims.	pushing cases together - then remove

6