CAULK
Remove Shipping Accessories From Case. Add Sealant.
Remove anything8from case that may interfere with case joining (eg. ship- ping braces). Run a bead of sealant around entire end before pushing cases tightly together.
4 | 5 |
3 |
|
2 | 1 |
Bolt Cases Together Using Bolt Holes Provided
Push cases9tightly together. Bolt cases together through the four holes provided. Tighten until all margins are equal; do not over tighten.
CAULK |
Add Sealant to Top Case Joint.
Once cases10are pushed tightly together and bolted run a bead of sealant along the top joint.
ACRYLIC |
TAPE |
PIPE |
CHASE |
Caulk Pipe Chase, Install Acrylic Tape
Seal joints11along pipe chase seam with the caulk provided. Apply acrylic tape over pipe chase seam. Tape is found with the ship loose items and acts as a watershed preventing water from settling in case joint.
TANK | UPPER |
| KICKPLATE |
KICKPLATE | RETAINER |
| |
BRACKET |
|
| “J” RAIL |
Install Upper Kickplate Retainer & “J” Rail
Attach 12the upper kickplate retainer by placing it against the bottom of the tank. Line up the retainer with the kickplate bracket and attach with the screws provided. Set the “J” rail flush to the floor and attach it to the kickplate bracket with the screws provided.
| KICKPLATE |
PEDESTAL | BRACKET |
Install Pedestals
The
| UPPER |
| KICKPLATE |
| RETAINER |
“J” RAIL | KICKPLATE |
|
Insert Kickplate
END |
KICKPLATE |
PEDESTAL |
BASEFRAME |
Install End Kickplate
|
|
|
|
|
|
|
|
| BUMPER |
|
|
TRACK |
|
|
|
| |
|
| TRIM |
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
|
|
Install Bumper Trim
Insert top14of kickplate into the upper kickplate retainer. Slide the kickplate up into retainer then down on the “J” rail.
End kickplates15are installed only on cases with ends. Fit the end kickplate under the end and secure it to the base- frame.
7
Insert the16bumper trim into the track that is mounted to the front panel of the case.
