USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE

 

FUNCTIONS

- 24 -

These buttons are for operating the TV.

 

NOTE: Refer to the instruction manual of the VCR for operation of the buttons exclusively for the VCR.

USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS

CLU-432U Illustration

CLU-431UI Illustration

Operating the pre-coded function for your cable/satellite box.

This remote is designed to operate different types of cable boxes and satellite systems. You must first program the remote to match the remote system in your cable/satellite box. (Refer to page 34.)

1.Turn ON your cable/satellite box.

2.Aim the remote control at the front of your cable/satellite box.

3.Press the CABLE button on the remote to switch to cable/satellite box mode.

4.Hold down the CABLE box button on the remote, enter the two digit preset code that matches your cable/satellite box as shown on page 34. The remote will turn off your cable/satellite box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after five seconds, try another two digit preset code.

5.The remote will now control your cable/satellite box.

NOTES:

1.If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite box code has not been precoded into the remote.

2.In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please consult your cable/satellite box operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure stated above.

4.If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP function.

5.The LST-CH button will act as the cable/satellite box ENTER button if required.

6.The SLEEP button will act as your cable/satellite box '100' button if required.

1 CABLE Button

This button allows the remote to control your cable/satellite box by setting it to cable/satellite mode.

2 PRECODED CABLE/SATELLITE BOX buttons

These buttons transmit the chosen precoded cable/satellite codes.

3 EXCLUSIVE TV buttons

These buttons are for operating the TV.

CABLE/SATELLITE, AND VCR CODES

 

CABLE BRANDCODES

ABC

00, 07, 08, 18, 19, 21, 37, 38, 53

Antronix

40

 

Archer

12, 25, 40

 

Belcor

33

 

Cable Star

33