Hitachi 32HDX60 Remote Control, CD, PVR, AMP buttons, CHANNEL selector buttons, SLEEP button

HOW TO USE THE REMOTE

TO CONTROL YOUR PLASMA TV

CD, PVR, AMP buttons

When pressed, each of these buttons will blink to indicate the remote is in Audio mode or PVR mode (see page 39).

CHANNEL selector buttons

CHANNEL selector buttons are used to select channels, lock access code, etc.

Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.

Channel selection may also be performed by pressing CH up ( ) or down ( ).

NOTE: The Plasma TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode (see page 50).

SLEEP button

Press this button to display the sleep timer in the lower center of the screen. Every subsequent press of this button will add 15 min- utes to this timer, up to a maximum of three hours. Once set, use INFO when you want to view time remaining. If the SLEEP but- ton is pressed while the timer is set, it will reset to the original condition.

INFO button

Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second audio program (SAP), the time, CHANNEL ID and if the SLEEP timer is set.

REMOTE CONTROL

Day/Night

Closed Mode

Captioning

			3:32 PM			Time
			Ant A 22			Main Picture Source
			Stereo			Audio Broadcast
					R	Broadcast Rating
			1080i Format			Signal Format
						Wide
Day		4:3 Expanded				Mode
CC Off		0:00 AM			-:--	Sleep Timer
	View
				Zzzz

3:32 PM S-IN:3

VID 3

3:32 PM YPBPR:1

VID 1

When an S-VIDEO Input is connected to VIDEO: 3.

When a COMPONENT VIDEO: Y-PBPRInput is connected to VIDEO: 1.

THE

Off Timer

ANTENNA button

The ANT button will select between Antenna A and Antenna B each time the button is pressed.

3:32 PM
Ant A 15	ANT
Stereo
G

TV/RGB button

Press this button to toggle between RGB (Analog) mode and TV mode.

3:32 PM

Ant B 22

Stereo

R

26