Hitachi 42EDT41A AV1 Displays the Video input signal of the sub-screen

MULTI PICTURE (PinP)

Displaying MULTI PICTURE

If the PinP button on the remote control is pressed MULTI PICTURE will display.

PinP button

RECALL button

A/B button

RETURN button

SELECT button

THE REMOTE CONTROL

Activating the P-in-P mode from the RGB input screen

Pressing the PinP button one time will display 2 pictures.

•This mode can be available from RGB1(DVI-PC) and RGB2(RGB) Input.

•The speaker icon can be shifted up and down by pressing the A/B button; the audio of the video will be output from the side on which the speaker icon is located.

• The sub-screen position can be selected up and down by pressing and SELECT buttons.

•The sub-screen can be selected with the AV1, AV2, AV3, AV4 and TV channel number buttons from the status that the speaker icon appears on the left side of AV* as shown in the diagram to the right.

•Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.

•"Frequency Mode" in the Setup Menu should be set to Movie when sub-screen is the component signal of 1080i/50 or 1080i/60.

AV1: Displays the VIDEO input signal of the sub-screen.

Activating the Split mode from the video input screen

Pressing the PinP button one time will display 2 pictures.

•The speaker icon can be shifted left and right by pressing the A/B button; the audio of the video will be output from the side on which the speaker icon is located.

•The same video input mode cannot be selected for both screens at the same time.

•Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.

•When the Video input is set to RGB Video, this Split mode is not possible.

•Refer to the table for 2 pictures (Split) mode.

RGB2

AV1

(Sub- screen)

AV1 AV2

29