Hitachi 32HDT55, 42HDT55, 50HDT55 Rear Panel Jacks, Monitor OUT, Audio OUT

REAR PANEL JACKS

REAR PANEL OF THE AVC CENTER

ANT B

TO CONVERTER

ANT A

ANALOG INPUT

Please use HITACHI specified cable.

S-VIDEO

S-VIDEO

S-VIDEO

Y/VIDEO

Y

TO MONITOR

VIDEO

VIDEO

VIDEO

L

L/(MONO)

L

PB

PB

AUDIO

L/(MONO)

L/(MONO)

L/(MONO)

L/(MONO)

DVI-HDTV

AUDIO

R

R

R

PR

R

PR

R

R

R

AC IN

AUDIO

AUDIO

AUDIO

AUDIO

AUDIO

MONITOR OUT

INPUT 4

INPUT 3

IR BLASTER

INPUT 2

INPUT 1

INPUT 1

AUDIO OUT

RGB

TruBass SRS and

symbol are trademarks of SRS Labs, Inc.

32”/42” Monitor Bottom View

2

50” Monitor Bottom View

FIRST TIME USE

2

Antenna Input/Output

The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture (ANT B cannot be displayed as a sub-picture). The antenna output labeled “TO CONVERTER” allows the ANT A connection to pass directly to a different source such as a cable box, only when ANT B is displayed as a main picture.

Audio/Video Inputs 1, 2, 3 and 4

The VID1~VID4 buttons will select each video source each time they are pressed. Use the audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (if you have mono sound, insert the audio cable into the left audio jack).

MONITOR OUT

These jacks provide fixed audio and video signals (ANT A/B, INPUT 2~5) which are used for recording. Use the S-VIDEO Output for high quality video output. Component signal to Input 1 and 2, RGB and DVI-HDTV inputs will not have monitor output.

AUDIO OUT

These jacks provide fixed audio output for all audio sources (ANT A/B, INPUT1~5, and RGB) to a separate stereo amplifier.

S-VIDEO Inputs 3 and 4

Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.

NOTES: 1. You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a time.

2. S-VIDEO output may be used for recording, only when the input is of S-VIDEO type.

Component: Y-PBPRInputs

Inputs 1 and 2 provide Y-PBPRjacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may use composite video signal for INPUT 2. INPUT 1 does not accept composite video signal.

NOTES: 1. DO NOT connect composite VIDEO and S-VIDEO to Input 3, 4 or 5 at the same time. S-Video has a higher priority over video input.

2.Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the AVC Box’s PB input and the components R-Y output to the AVC Box’s PR input.

3.Your component outputs may be labeled Y-CBCR. In this case, connect the component CB output to the AVC Box’s PB input and the component CR output to the AVC Box’s PR input.

4.It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-PBPRinputs (See page 45).

5.To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-PBPRjacks, RGB and DVI-HDTV inputs.

11