CAUTION: A pattern burn may develop if the sub-picture is left in the same corner permanently. If the PIP feature is used frequently, occasionally shift the sub-picture to a different corner.

NOTE:

1.Only sound from the main picture can be heard, unless you choose PIP from wireless mode and use the

"TRANSMITTER OUT" outputs on the rear panel. (See page 44.)

2.Each strobe freeze frame is delayed about 0.3 (3/10) second.

USING THE REMOTE TO CONTROL VCR FUNCTIONSOperating the pre-coded function for your VCR

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system in your VCR. (Refer to page 26)

1.Set the MULTI-PAGE select switch to "VCR".

2.Turn ON your VCR.

3.Aim the remote control at the front of your VCR.

4.While holding down the VCR POWER button on the remote, enter the 2 digit preset code that matches your VCR as shown on page 26. The remote will turn off your VCR when the correct 2 digit preset code is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off after 5 seconds, try a different

2digit preset code.

5.The remote will now control your VCR.

NOTES:

1.If your VCR cannot be operated after performing the above procedures, this means that your VCR's codes have not been precoded into the remote.

2.In the unlikely event that your VCR cannot be operated after performing the above