UP function.

￿ PRECODED FOR CABLE BOX

These buttons transmit the chosen precoded CATV codes.

￿ EXCLUSIVE TV BUTTONS

These buttons are for operating the TV.

Click to see Remote.

USING THE REMOTE TO CONTROL AUDIO EQUIPMENT FUNCTIONS

Operating the pre-coded function for your audio equipment

This remote is designed to operate different types of audio equipment. You must first program the remote to match the remote system in your audio equipment. (Refer to page 26)

1.Set the MULTI-PAGE select switch to"AUDIO".

2.Turn ON the audio component you wish to control with your remote (AMP, CD, or TAPE).

3.Aim the remote control at the front of your audio equipment.

4.While holding down the button on the remote which corresponds with the component you wish to control (AMP, CD, or TAPE), enter the 2 digit preset code that matches your audio component as shown on page 26. The remote will turn off your audio component when the correct 2 digit preset code is entered. When this occurs, the remote control is programmed for your audio component. If the audio component does not turn off after 5 seconds, try a different 2 digit preset code.

5.The remote will now control your audio component.

6.Repeat steps 2-5 until all audio equipment preset codes are programmed into the remote.

NOTES:

1.If your audio component cannot be operated after performing the above procedures, this means that your audio components codes have not been precoded into the remote.

2.In the unlikely event that your audio component cannot operate after performing the above procedures, consult your audio component operating guide.

3.The remote control will remember the codes you have programmed in until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure stated above.

4.If your audio component does not have a power function, the remote will issue another