USING THE REMOTE TO CONTROL DVD FUNCTIONS
Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player (refer to pages
1.Turn ON your DVD player.
2.Aim the remote control at the front of your DVD player.
3.To switch to DVD
4.Hold down the ENT button on the remote and enter the four digit preset code that matches your DVD player, as shown on pages
5.Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different four digit preset code.
6.The remote will now control your DVD player.
THE REMOTE CONTROL
7.You will need to set the display type of your DVD player to 16:9 widescreen.
NOTES:
1.If your DVD player cannot be operated after performing the above procedures, your DVD player’s code has not been precoded into the remote.
2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
aPRECODED DVD Buttons
These buttons transmit the chosen precoded DVD codes.
bEXCLUSIVE TV Buttons
These buttons are for operating the TV.
a
b
A/V NET
b
GUIDE
b
a |
a |
a |
MY DVD PLAYER CODE IS:
NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.
44
