A/V NETWORK SETUP WIZARD
5.Follow the steps below to setup your A/V network (See page 20 for A/V Network Codes).
There are six steps in the setup procedure (VCR setup example below).
HITACHI AV NET Wizard (step 1 of 6)
This Wizard helps you with
VCR connections and settings.
Would you like to setup or
modify your VCR?
BACK |
| NEXT |
HITACHI AV NET Wizard (step 2 of 6)
Follow the digrams shown in Hitachi’s
Easy Graphic Guide to connect your VCR.
Carefully position the IR “mouse” in front of your VCR as shown in the diagrams.
BACK |
| NEXT |
HITACHI AV NET Wizard (step 3 of 6)
Find your VCR
and enter it here - - - -
(Enter Code “9999” to uninstall)
| BACK |
|
| NEXT |
|
|
|
|
|
|
|
|
|
| Proper Code Entered | ||
|
|
| |||
|
|
|
| from page 20. | |
|
|
|
| ||
HITACHI AV NET Wizard (step 4a of 6)
| Which TV Rear Panel Input | |||||
| is connected to your VCR? | |||||
( | ) ANT A | ( | ) INPUT 3 | |||
( | ) ANT B | ( | ) INPUT 4 | |||
( | ) INPUT 1 | ( | ) INPUT 5 | |||
( | ) INPUT 2 |
|
|
| ||
|
|
|
|
|
| |
|
| BACK |
| NEXT |
| |
HITACHI AV NET Wizard (step 5 of 6)
Turn ON your VCR then press
each of the 3 function keys below.
Your VCR should respond to one of these
keys. Now press NEXT to continue.
POWER |
|
| PLAY |
| CH UP | ||
|
|
|
|
|
|
|
|
| BACK |
|
| NEXT |
| ||
HITACHI AV NET Wizard (step 6 of 6)
Did your VCR respond to
POWER, PLAY or CH UP?
Press DONE to finish this wizard or
HELP to trouble shoot settings.
HELP |
| DONE |
HELP
TROUBLE SHOOTING
Please check connections shown in the EASY GRAPHIC GUIDE.
If connections are correct,
try a different manufacturers code
for your VCR |
| 0 4 3 6 |
| |
|
|
|
|
|
BACK |
| NEXT |
| |
If Error
ANT A/B
DONE
ATTENTION
The
BACK |
| NEXT |
HITACHI AV NET Wizard (step 4b of 6)
Which RF channel does your VCR
use to send video to the TV?
( ) Channel 03
( ) Channel 04
BACK |
| NEXT |
HITACHI AV NET Wizard
Congratulations!
Your VCR is now conected
to your AV network.
From Step 3, once you enter “9999”, the following message appears.
HITACHI AV NET Wizard (step 3b of 6)
This will uninstall VCR on INPUT 1.
Would you like to proceed?
BACK |
| YES |
6.Enter “9999” to uninstall the equipment from your A/V Network.
7.See Remote Control A/V NET button usage on page 24.
NOTES: 1. If your equipment cannot be operated after performing the above procedures, your equipment code has not been pre- coded into the A/V Net.
2.In the unlikely event that your equipment receiver cannot be operated after performing the above procedures, please consult your equipment receiver operating guide.
19
