Manuals / Hitachi / Computer Equipment / Personal Computer

Hitachi 8000 Replace the access panel, If the computer was on a stand, replace the stand, Enww

Models: 8000

1 48

Download 48 pages 36.53 Kb

Page 37

9.Replace the access panel.

b.Insert the new battery and position the clip back into place. Figure B-3Removing a Coin Cell Battery (Type 3)

NOTE: After the battery has been replaced, use the following steps to complete this procedure.

9.Replace the access panel.

10.If the computer was on a stand, replace the stand.

11.Reconnect the power cord and turn on the computer.

12.Reset the date and time, your passwords, and any special system setups, using Computer Setup.

13.Lock any security devices that were disengaged when the computer cover or access panel was removed.

ENWW

31

Image 37

Hitachi 8000 manual Replace the access panel, If the computer was on a stand, replace the stand, Enww

Contents

HP Compaq 8000 Elite Ultra-Slim Desktop Business PC Hardware Reference GuideHP Compaq 8000 Elite Ultra-Slim Desktop Business PC Hardware Reference GuideFirst Edition November Document Part Number About This Book ENWW iv About This Book1 Product Features Table of contents2 Hardware Upgrades Appendix A SpecificationsAppendix D Electrostatic Discharge Appendix C Security Lock ProvisionsIndex Standard Configuration Features 1 Product FeaturesTable 1-1 Front Panel Components Front Panel ComponentsTable 1-2 Rear Panel Components Rear Panel ComponentsKeyboard Using the Windows Logo KeyTable 1-3 Keyboard Components Table 1-4 Windows Logo Key Functionsarrow Table 1-4 Windows Logo Key Functions continuedWindows Logo Key + + on numpad Serial Number LocationZooms in Windows Logo Key + - on numpadServiceability Features 2 Hardware UpgradesWarnings and Cautions Connecting the Power Cord Removing the Computer Access Panel 2. Tighten the thumbscrew to secure the access panel Replacing the Computer Access PanelFigure 2-3 Replacing the Computer Access Panel 10 Chapter 2 Hardware UpgradesRemoving and Replacing the Front Bezel 4. Reconnect the power cord and turn on the computer Figure 2-5 Replacing the Front Bezel 2. Replace the access panel12 Chapter 2 Hardware Upgrades To replace the front bezelRemoving a Bezel Blank Changing from Desktop to Tower Configuration SODIMMs Installing Additional MemoryDDR3-SDRAM SODIMMs Table 2-1 SODIMM Socket Locations Populating SODIMM Socketson page Installing SODIMMs11. Replace the access panel Figure 2-10 Installing a SODIMM18 Chapter 2 Hardware Upgrades Figure 2-9 Removing a SODIMMRemoving the Existing Optical Drive Replacing the Optical DrivePreparing the New Optical Drive Installing the New Optical Drive6. Reconnect the power cord and turn on the computer Figure 2-13 Installing the Optical Drive 4. Replace the access panel5. If the computer was on a stand, replace the stand ENWWReplacing the Hard Drive Replacing the Hard Drive ENWWFigure 2-18 Sliding the Hard Drive into the Carrier 24 Chapter 2 Hardware UpgradesFigure 2-19 Lowering the Hard Drive and Replacing the Guide Screws ENWW16. Replace the computer access panel Figure 2-20 Installing the Hard Drive Carrier18. Reconnect the power cord and turn on the computer 17. If the computer was on a stand, replace the standInstalling and Removing a Port Cover Table A-1 Specifications A SpecificationsApproximate Weight Power SupplyRated Input Current maximum Table A-1 Specifications continuedB Battery Replacement Type TypeType 11. Reconnect the power cord and turn on the computer 9. Replace the access panel10. If the computer was on a stand, replace the stand ENWWC Security Lock Provisions Installing a Security LockHP/Kensington MicroSaver Security Cable Lock Figure C-2 Installing a Cable with a Port Cover Installed PadlockFigure C-3 Installing a Padlock Installing a Security Lock34 Appendix C Security Lock Provisions HP Business PC Security LockENWW Front Bezel Security 5. If the computer is on a stand, remove the computer from the stand 6. Remove the access panel and front bezelFigure C-8 Retrieving the Front Bezel Security Screw 8. Replace the front bezel10. Replace the access panel Figure C-9 Installing the Front Bezel Security Screw12. Reconnect the power cord and turn on the computer Installing a Security LockPreventing Electrostatic Damage D Electrostatic DischargeGrounding Methods Computer Operating Guidelines and Routine Care Cleaning Optical Drive PrecautionsSafety Shipping PreparationIndex