English
(2) Setting to cut crown moldings at positions w and e in Fig. 28 (see Fig. 31):
qTurn the turntable to the left and set the Miter Angle as follows:
*For 45°type crown moldings: 35.3° ( mark)
* For 38°type crown moldings: 31.6° ( mark)
wTilt the head to the left and set the Bevel Angle as follows:
* For 45°type crown moldings: 30° ( |
| mark) | |
* For 38°type crown moldings: 33.9° ( |
| mark) | |
| |||
ePosition the crown molding so that the lower surface (B in Fig. 27) contacts the fence as in Fig. 32.
|
|
|
| Head |
| Head | |
|
|
| Bevel |
| Bevel | ||
|
|
| Angle Scale |
| Angle Scale | ||
q |
|
|
|
| e | ||
|
| r | w |
| |||
|
|
|
|
|
| ||
|
|
|
|
| Fence | Fence |
|
|
|
|
|
|
|
| |
|
|
|
|
| Base |
| Base |
|
|
|
|
|
|
| |
Miter | Angle | Scale | Turntable |
| Miter Angle Scale | Turntable | |
|
|
| Fig. 29 |
| Fig. 31 | ||
Fence |
|
|
| Fence |
| ||
| A |
| B | B | A | ||
|
|
|
| ||||
|
|
|
|
|
|
| |
|
|
| Table on Base | Table on Base | |||
|
|
| Fig. 30 |
| Fig. 32 | ||
11. Groove cutting procedures
Cut grooves with saw blade | 8mm | 8mm | |
Wing Nut | Depth Adjustment Bolt | ||
|
a |
|
b | Bottom Line of |
| the Groove |
| Turntable |
Fig. 33 | Fig. 34 |
Grooves in the workpiece can be cut as indicated in Fig. 33 by adjusting the 8mm depth adjustment bolt.
Cutting depth adjustment procedure:
(1)Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.
(2)Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of the base (see b in Fig. 33).
(3)The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE: When cutting a single groove at either end of the workpiece, remove the unneeded portion with a chisel.
20