Warning
Be careful in handling the power cord.
∙Do not scratch, damage or process the power cord. Do not bend it forcibly. Also do not put a heavy object on it, do not heat it and do not pull it. If you do, the power cord may be damaged and it may cause a fire, electric shock, etc.
⋅Do not pull the cord.
⋅Do not put a heavy object on it.
⋅Do not damage the cord.
⋅Do not put it near a heating
device.
∙Be careful that this unit is not placed
on the power cord. The power cord may be damaged and it may cause a fire, electric shock, etc. If the cord is covered with a carpet, etc. a heavy object may be put on it without your realizing it.
∙If the cord is damaged (core wire is exposed, disconnected, etc.), ask
your dealer to replace it. It may cause a fire, electric shock, etc.
∙Check that no dirt adheres to the
power plug and fully insert without any play. If dirt adheres or the connection is incomplete, it may cause a fire, electric shock, etc.
∙The outer shield of power cord must be connected to ground.
If you do not, it may cause a electric shock.
ENGLISH
Do not stare directly into the laser aperture.
∙The laser pointer on the remote control unit radiates the laser beam from the laser aperture.
∙Do not stare into the laser aperture or radiate the laser beam to other persons as the laser emitted is a class 2 laser and it could damage you vision , etc.
Especially pay attention if children are present.
∙The three labels below are caution labels for the laser beam.
CAUTION
LASER RADIATION -
DO NOT STARE INTO BEAM
WAVE LEGTH : 670nm
MAX. OUTPUT : 1mW
CLASS 2 LASER PRODUCT
RADIAZIONI LASER
NON GUARDARE NEL RAGGIO LUCE
APPARECCHIO LASER DI CLASS 2
RAYONNEMENT LASER | MANUFACTURED |
NE PAS REGARDER DANS |
|
LE FAISCEAU APPAREIL | |
A LASER DE CLASSE 2 |
|
| |
NICHT IN DEN STRAHL |
|
BLICKEN LASAER KLASSE 2 | MANUFACTURER:A |
|
|
C A U T I O N
LASER RADIATION -
DO NOT STARE INTO BEAM
WAVE LEGTH : 670nm
MAX. OUTPUT : 1mW
CLASS 2 LASER PRODUCT
AVOIDE
RADIATION IS EMITTED
FROM THIS APERTURE
LASER APERTURE
5
